PolyDissolve™ S1

PolyDissolve™ S1 is a water dissolvable support for PLA, TPU, PVB and Nylon based filaments from our portfolio. It is specifically engineered to have a perfect interface with these materials while also displaying good solubility.

PHYSICAL PROPERTIES

Property
Testing Method
Typical Value

Density

ISO1183, GB/T1033

1.13 g/cm3 at 23 °C

Melt index

220°C, 2.16kg

7.8 g/10min

Light transmission

N/A

N/A

Flame retardancy

N/A

N/A

CHEMICAL RESISTANCE DATA

Property
Typical Value

Effect of weak acids

Poor

Effect of strong acids

Poor

Effect of weak alkalis

Poor

Effect of strong alkalis

Poor

Effect of oils and grease

Not Available

Note:

Good: Material may get minor attack after long periods of storage with chemical at ambient temperature

Fair: Material can be used for short time contact with chemical at ambient temperature

Poor: Material becomes unstable on contact with chemical at ambient temperature

MOISTURE ABSORPTION CURVE

Material Compatibility

Material
Adhesion with PolyDissolve™ S1

PLA based material from Polymaker’s portfolio

++

PETG based material from Polymaker’s portfolio

+

ABS based material from Polymaker’s portfolio

- -

PC based material from Polymaker’s portfolio

- -

PVB based material from Polymaker’s portfolio

++

TPU based material from Polymaker’s portfolio

++

Nylon based material from Polymaker’s portfolio

++

Note:

++ support the model very well

+generally, support the model depending on its geometry

-generally, doesn’t support the model depending on its geometry

--do not support the model

RECOMMENDED PRINTING CONDITIONS

Parameter

Nozzle temperature

215 – 225 (℃)

Build surface treatment

PC and Texture PEI (Glue when needed)

Build plate temperature

25 - 60 (˚C)

Cooling fan

ON

Printing speed

50 – 150 (mm/s)

Retraction distance

1 - 3 (mm)

Retraction speed

20 - 40 (mm/s)

Closure Chamber

No Needed

Recommended support material

-

Drying setting * Based on 0.4 mm nozzle. Printing conditions may vary

80˚C for 12h with different nozzle diameters

  • Based on 0.4 mm nozzle. Printing conditions may vary with different nozzle diameters

Note:

It is highly recommended to use the PolyBox™ when printing with PolyDissolve™ S1 and to store it in the resealable bag.

DISCLAIMER:

The typical values presented in this data sheet are intended for reference and comparison purposes only. They should not be used for design specifications or quality control purposes. Actual values may vary significantly with printing conditions. End- use performance of printed parts depends not only on materials, but also on part design, environmental conditions, printing conditions, etc. Product specifications are subject to change without notice.

Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/ recycling practices of Polymaker materials for the intended application. Polymaker makes no warranty of any kind, unless announced separately, to the fitness for any use or application. Polymaker shall not be made liable for any damage, injury or loss induced from the use of Polymaker materials in any application.

Last updated

Was this helpful?